| Hippotizer Forum Scandinavia http://www.digigobos.com/forum/ |
|
| Using dual outputs and what can happens... http://www.digigobos.com/forum/viewtopic.php?f=9&t=155 |
Page 1 of 1 |
| Author: | peppe [ Wed Jul 01, 2009 12:21 pm ] |
| Post subject: | Using dual outputs and what can happens... |
It is not at all uncommon for the Hippotizer engine to not be able to start completely straight after changing modes in the engine settings, this has to do with the data that the engine receives from the ATI card being a bit unreliable, I often get grey preview windows or black windows - but this will always be cleared by shutting down the host and restarting. The problem with the ongoing restarts not being right are almost definitely to do with EDID information not being received or wrong EDID info. Using the Matrox boxes is one way to go, so is using EDID storage boxes such as the DVI Detective Plus (Plus is much better than the normal one) or the DVI Wizard. Sometimes errors can be seen when using LED Walls ( lower resolutions ) running a Lighthouse LED wall, this processor is sending very bad edid information and this causes problems BIGTIME.. Solution: Use a splitter between the outputs and the processors and connect a monitor with proper edid and resolution option to the splitters aswell. Or, use a triplehead Digital, you can get out VGA straight from the triplehead by putting a DVI/VGA adapter in the ass of the triplehead. Some great collected info from Nigel at GH and Johan West, the guys that always have a good answer!! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|