Hippotizer Forum Scandinavia http://www.digigobos.com/forum/ |
|
VGA output workaround on the new model http://www.digigobos.com/forum/viewtopic.php?f=13&t=50 |
Page 1 of 1 |
Author: | peppe [ Thu Sep 04, 2008 8:59 pm ] | ||
Post subject: | VGA output workaround on the new model | ||
When using the old V3 case the DVI connector at the back had a combination of pins to allow you to use either a DVI or DVI to VGA connector. However because it´s now have a split of DVI and RGBHV the pins you previously used in the DVI connector to give VGA are not there anymore because they go to the RGBHV connection (the 5 BNC connectors below the DVI one). However it is still possible if you use the RGBHV connector,(5 BNC to VGA, see picture)
|
Author: | peppe [ Sun May 24, 2009 6:53 pm ] |
Post subject: | Re: VGA output workaround on the new model |
I did found out ( and several people around the world ) that one factory in Taiwan or whatever country that make this ones on OEM for many brands (Deltaco etc. ) had one idiot working there, and the result was that the H is switched with the V markings! So if you have problems with a total black screen, no contact with it, try to switch the H (horisontal sync ) and the V (Vertical sync ) on the cable.... Good to know! ( all my suppliers have noticed the same, so when you buy one in a store, the are often nice to tell you this.....) |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |